The industry leader in power and control solutions. The system utilizes automotive grade approved high-power, high-temp, ultra-reliable components with a maximum 100 amp capacity! The sPOD SourceSE is a fully programmable digital CAN-Bus controlled system utilizing state-of-the-art technologies. OEM vehicle specific simple installation hardware, engineered and 100% manufactured in the United States.
Features: · Fully programmable Digital controlled system. · Expandable (Daisy Chained selectable) to up to 32 circuits with simple plug-n-play features!
· Low voltage cutoff (LVCO) battery protection circuit has spec voltage cutoff at 11.2 VDC with a two-minute delay before shutting down the SourceSE. This is useful when you have accessories turned on while the vehicle is not running. When the vehicle starts, the accessories can then be used again.
The low voltage battery protection circuit can be turned off with the DIP switches. · No more worrying about what rated fuse to install! The system will protect from 1.5 amps to 30 amps automatically. The SourceSE incorporates a failsafe self-healing fault protection system. Fuses have been eliminated (for all accessory outputs) and replaced with current-sensing MOSFETs controlled by a microprocessor.
This is a great feature for low maintenance and troubleshooting · Shield receptacle for the optional Bluetooth module for a plug-n-play end-user upgrade. This creates a scalable platform for future optional enhancements. · One single ATM mini-style fuse for LVCO protection and reset. Touchscreen Control Module Features: The new touchscreen controller is small but packs a BIG punch!(3-3/4w X 2-7/8h X 5/8 thk) The control module is a 3.5-inch LED backlit TFT LCD screen with a resolution of 320 x 240, 16.7m colors and a viewing angle of 180 degrees housed in a billet aluminum case with a 1 RAM mount installed on back panel. The connection between the SourceSE and the touchscreen uses a small 90 degree 3.5mm standard 4 pin audio jack with a RJ-45 Ethernet plug on the SourceSE end. Standard cable length will be 12 feet. · Customizable legends (3 lines of text) · Voltage feedback (vehicles battery/alternator voltage) · SourceSE board temperature feedback (shown on screen) · Automatic power off after 10 minutes of being inactive · One touch screen off function · One second hold on off button shuts all circuits down · Automatic system shut down when touchscreen is unplugged · Touchscreen housing is NOT plastic but rather, an aluminum billet machined clam-shell designed with several options for mounting · Two ports for connection; one on top and one on bottom · Touchscreens can be daisy chained for remote operations (EG: one panel in cab and one panel in far back of truck) can easily add up to 10 touchscreens · Selection of up to 4 sPOD SourceSE to have control of up to 32 circuits.
To make your shopping experience as simple and easy as possible, please refer to our company policies shown below. Tracking numbers are updated manually, so please allow enough time for your information to be entered after your order has been placed. AZ Offroad & Performance, Inc. & will do everything possible to ensure the customer's satisfaction.We are not responsible for install mistakes. The RA # must be on the outside of each package with the RA # in a visible area. Any package without the RA # will be refused. The item "SPOD 8 Circuit SE System with Touchscreen Module fits 2007-2018 Jeep Wrangler JK" is in sale since Tuesday, May 16, 2017.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Other Parts". The seller is "azoffroadperformance" and is located in Phoenix, Arizona. This item can be shipped worldwide.